Home › Why a Water Heater Rumbles, Pops or Bangs
Why a Water Heater Rumbles, Pops or Bangs
The noise is steam escaping from under a layer of sediment. What it means for efficiency, capacity and the life of the tank.

Free to homeowners in Why a Water Heater Rumbles, Pops or Bangs — the contractor pays us for the introduction, you never do.
Answer first
The rumble is steam escaping from beneath a layer of sediment on the tank floor. It means the burner is heating sediment rather than water, which costs both efficiency and capacity, and it shortens the life of the tank by overheating the steel.
It is not the tank about to burst. It is water flashing to steam underneath a layer of mineral that should not be there.
What this site is
HeaterRelay is a referral service, not a contractor. We connect homeowners with independent contractors. Contractors are required to hold whatever credential their state or municipality demands. Every state page sets out who licenses plumbers there and where to check, so you can confirm before work begins. We carry out no work, we sell no equipment, we do not set prices, and we never charge homeowners anything — the contractors in our network pay us when we route them a call.What the noise is
Minerals settle out of the water and collect in the bottom of the tank. On a gas heater the burner is underneath that layer, so it heats the sediment rather than the water. Pockets of water trapped in the sediment flash to steam and force their way up through it, and that is the rumble or the series of pops.
What it costs you
Three things. The volume the sediment occupies is capacity you no longer have. The layer insulates the water from the burner, so the heater burns longer for the same result. And the tank bottom runs hotter than it was designed to, which shortens its life.
Where the minerals come from
From the water supply. Harder water deposits more, faster, which is why the same heater lasts differently in different towns.
What can be done
Draining sediment is routine maintenance on a heater that has been kept up with. On one that has rumbled for years it is less straightforward — a drain valve that has never been opened can fail to close again, and a heavily scaled tank may not drain at all. That is worth a contractor rather than a first attempt.
Know the fuel and the symptom? That is most of the call.Gas and electric heaters fail in almost entirely different ways, so saying which you have gets you to the right person faster. We route the call and never charge you for it. Water heaters are what we write about; the number goes further.
Call (866) 871-2892
